MK MACHINING ROLLS OUT NEW SCOPE CAPS

MK Machining has recently announced the roll out of their new Scope caps.

MK Machining states “MK Machining is excited to offer our MK Machining Scope Caps.

Scope caps are made out of a Nylon 11 material using an HP MJF 5200 3D Printer.

Nylon 11 is slightly flexible to fit over your scope objective without becoming brittlem and is strong enough to handle wear and tear.

Scope caps feature a custom made spring for full range opening and closing of the cap without unnecessary noise.

Caps are a press fit over the objective and are tightened down using a single bolt.

Compatible with MK Machining ARDs. Below you will find the various objective and eyepiece diameters that we offer and what scopes we have tested them with.

The tolerance on our caps allows for an objective that is approximately .005″ smaller than the listed diameter.”

SUPPORT:

  • ATHLON ARGOS BTR 24mm 1.810 1.655
  • VORTEX STRIKE EAGLE 24mm 1.810 1.698
  • KAHLES 624i 56mm 2.435 1.700
  • LEUPOLD MK5 44mm 2.106 1.713
  • VORTEX DIAMONDBACK TACTICAL 44mm 2.008 1.733
  • VORTEX DIAMONDBACK TACTICAL 50mm 2.252 1.733
  • NIGHTFORCE ATACR 7-35X 2.560 1.739
  • ATHLON ARES BTR G2 56mm 2.503 1.753
  • BURRIS XTRiii 56mm 2.500 1.758
  • VORTEX STRIKE EAGLE 56mm – 5-25 2.515 1.800
  • ATHLON ARGOS BTR G2 50mm 2.247 1.812
  • KAHLES 525 56mm 2.435 1.812
  • ATHLON ARGOS BTR G2 56mm 2.503 1.812
  • VORTEX RAZOR HD GEN 2 – 4.5-27 2.557 1.812
  • ATHLON ARES ETR 56mm 2.503 1.831
  • ZERO COMPROMISE ZC527 2.476 1.907
  • VORTEX VIPER GEN 2 3-15×44 2.084 1.812
  • VORTEX VIPER GEN 2 5-25×56 2.298 1.812
  • TANGENT THETA 5-25 2.557 1.791
  • Element Titan 5-25×56 FFP 2.542 1.794

To learn more about MK Machining. CLICK HERE

Leave a Reply